DRILLING LUBRICANT AND FRICTION REDUCER
BOSS-150 is a blend of amide acid. BOSS-150 is effective at reducing friction during horizontal and directional drilling. BOSS-150 disperses easily into any system.BOSS-150 reduces torque and drag, casing wear, wall sticking tendencies, and bit and bottom hole assembly balling. BOSS-150 will not damage any elastomers of down-hole motors.
Typical physical properties
Appearance: Aromatic Odor - Dark brown liquid
Specific Gravity: 0.9963
Active Content: 50-55%
Density: 7.9lbs a gal
Dispensability: 100% OBM and 99% WBM with agitating
High Torque, Excessive Hook-Load, or Difficulties Sliding: BOSS-150should be used in sweep form or to the entire system. Add 2-5% by volume to a 80-100 barrel slug tank. Pump 10-25 bbl sweeps as needed to solve the above problems.
Running Casing: Calculate 2-5% of BOSS-150 and spot the pill in the open hole ensuring that the top of the curve is where the top of the pill lands.
Stuck Pipe: Calculate 2-5% of BOSS-150 when the pill covers the stuck assembly and pump until the area is covered leaving a minimum of 20 bbls in the drill string. Pump 1 bbl every hour while working pipe free until desired results are achieved. Repeat procedure if necessary two more times to free pipe.
Handling and Storage
Observe normal precautions for industrial chemicals. Keep away from heat, sparks, and open flames. For more information, see material safety data sheet.
BOSS-150 is available in 55-gallon drums, 5 gal. buckets or 5 drum totes.